Paired with baseboard and stained or painted to match your trim, shoe molding (also known as base shoe) is a small, thin strip ofmolding that gives your room a finished look. Shoe molding adds a decorative touch while covering any gaps that might lie between the bottom of baseboard and the floor. Not all types of baseboard are suitable for installing shoe molding, however, so keep reading to find out if this slim trim is right for youplus how to install it flawlessly.

Tall baseboards were popular during the Greek Revival period in the early-to-mid 1800s, but the idea of adding shoe molding to baseboards began in Europe and the United States during the Victorian era of the late 1800s. Thats when mass production of wood trim made the molding readily available. Shoe molding, so called because its located at shoe level, caught on because it looked good and also helped seal out insectsand dirt.

Today, the main goal of both baseboard and shoe molding is to conceal the less-than-appealing transition between the bottom of the wall and the floor. Baseboard alone covers most of the gap, but because its larger than shoe molding, its relatively stiff and doesnt conform well to an uneven floor. Even after baseboard has been installed, you will often see small gaps here and there between the baseboard and the floor. Thats where shoe molding comes in. Its small size makes it slightly flexible, allowing it to be installed flat against the floor to give baseboard a professional finished look.

RELATED: 9 Ways to Dress Up a Room with Molding

The only caveat to installing shoe molding is that the bottom of the baseboard must be flat to accept the molding. For example, if you want to install standard -inch-high shoe molding, the lower -inch of the baseboard should be flat to allow the shoe molding fits snugly. Some more ornate baseboards feature grooves, slants, and curves within the lower -inch, which would prevent shoe molding from fitting flush against the baseboard.

If youve been looking at baseboard finishing trim, youve probably discovered quarter-round, too. As the name implies, this type of molding is one-quarter of a round dowel (split a dowel down the middle, then further split the halves, and youll have quarter-round). While quarter-round can be installed along the bottom of baseboard, trim carpenters and homeowners tend to prefer the sleeker look of shoe molding, which is taller and narrower than its curved counterpart.

Standard shoe molding, available athome improvement centersand lumberyards, comes in widths of 7/16-inch to -inch and ranges from -inch to 1-inch in height. Its also made in a variety of material options to match the different types of baseboard.

Installing shoe molding is a fairly straightforwarddo-it-yourself project, but you will need to create a coping joint (discussed below). The following tips will help you achieve a professional look.

Visit link:
Shoe Molding 101: Get to Know This Part of Baseboard - Bob Vila

Related Posts
June 22, 2020 at 4:42 am by Mr HomeBuilder
Category: Trim and Moulding