Top Tips for Security System Removal – Tip Sheet by SecuritySystemReviews.com

Charlotte, North Carolina (PRWEB) February 09, 2014

Often homeowners are focused on finding tips pertaining to the installation of a home security or alarm system, but security systems need to be removed in some instances as well. A few common reasons a homeowner may need to remove a system would be if theyre planning a move, or if they want to upgrade or replace an existing system.

Its certainly possible to remove a system, or components of a system, without causing damage to the wiring or the walls. Hardwired systems are definitely harder to remove than wireless security systems, however, which is why theyre becoming the most popular type of system.

The team at SecuritySystemReviews.com, a site that provides reviews of top security companies and equipment, including updated wireless security system reviews, has put together a few tips to ease the removal of a system.

1.Before doing any removal, contact the alarm monitoring company, and alert them that the system will be removed. The reason for this is because when a wire is disconnected or cut, or power is cut off to a security system, the alarm company will automatically dispatch the authorities.

2.Avoid tripping the siren. Most alarm systems have sirens that are located on a separate current from the rest of the system, so its usually necessary to disconnect the power that runs to the main portion of the security system, as well as the siren power supply.

3.Remove the control panel of the system lastthis is where all the other wiring for the system is located. Its easiest to install another panel in the same location, but if for some reason a homeowner isnt planning to install a new security system, the wiring thats behind the panel should be capped off.

4.If the battery pack of the system, which is located behind the systems control cabinet, is still in good condition, it can be reused for a security system replacement or upgrade. If a control cabinet isnt being reinstalled, or is being put in a new location, as with the control panel wiring, cap these wires as well.

5.For adhesive components, like door and window sensors, it may be necessary to use rubbing alcohol to fully remove them.

6.If a homeowner is planning to install or upgrade the security system, its probably best to leave all of the existing wiring in-place, rather than removing it. The reasons for this is because unless wiring is badly damaged, it can probably be used for the installation of a new security system, unless of course a homeowner is installing a wireless system. Even for the installation of wireless security systems, it may be best to wait until a professional installation company has visited, to determine whether or not the wiring should be removed.

Read this article:
Top Tips for Security System Removal - Tip Sheet by SecuritySystemReviews.com