Geothermal heating and cooling is becoming the most preferred source of heating and cooling.

How Geothermal Heating Works

Why settle for 90% when you can have over 600%

With geothermal cooling the heat is transferred from the building into the ground. Traditional ac transfers heat to the outside air which is hotter than the temperature you are trying to achieve indoors. Since the ground temperature at a depth of 6 ft (3 m) is about 53 degree (13 C) and since the ground transfers more efficiently than air, geothermal air conditioning is much more efficient. Also a large amount of excess heat is generated and can be used to heat your hot water, this also takes a little of the excess heat from the compressor.

This is geothermal heating and cooling in heating

1. The Evaporator Coil is a tube filled with water (Water Source Coil) and sealed inside of another larger tube filled with refrigerant Gas (Tube-In-A-Tube Heat Exchanger or a coaxial). 2. As the cold refrigerant Gas flows through the outside tube of the Evaporator Coil the water flowing through the inside tube of the Evaporator Coil warms the refrigerant Gas. (Purple) The heat pump cycle begins as cold liquid refrigerant passes through a heat exchanger and absorbs heat from the water circulating through the loop. 3. The Compressor then compresses the refrigerant Gas (The Gas that absorbed heat from the water circulating through the loop), causing it to become very hot and under high-pressure, raising its temperature to more than 160 degrees and pushes it into the Reversing Valve. (Red) 4. If the system thermostat is set to heating, then the Reversing Valve moves the hot high-pressure refrigerant Gas into the coil. (Red) 5. As the hot high-pressure refrigerant Gas moves through the Condenser Coil, the Fan blows air over the coil, heating the Conditioned Air Space and cooling the refrigerant Gas. The heat is removed from the refrigerant gas and transferred to air, which is then circulated into your house. (The temperature of the heated air or water is about 100 degrees.) The refrigerant gas cools and condenses into its liquid form as it moves through the Condenser Coil. (Pink) 6. When the cooled refrigerant Liquid moves through the Expansion Valve, the liquid evaporates back into its gaseous form in the Evaporator Coil and gets very cold in the evaporation process. (Blue) Then the process starts over again.

This is geothermal heating and cooling in cooling.

1. The Fan blows air over the Evaporator Coil, cooling the Conditioned Air Space and warming the refrigerant Gas. (Purple) Moving warm air out of your house and through the Evaporator Coil absorbing the heat into the refrigerant Gas. 2. The Compressor compresses the refrigerant Gas (The Gas that absorbed heat from the warm air circulating through house), causing it to become very hot and under high-pressure, and moves it into the Reversing Valve. (Red) 3. If the system thermostat is set to cooling, then the Reversing Valve moves the hot high-pressure refrigerant Gas into the Condenser Coil (Tube-In-A-Tube Heat Exchanger). (Red) 4. As the hot Gas flows through the outside tube of the Condenser Coil the water flowing through the inside tube of the Condenser Coil, heating the water and cooling the refrigerant Gas., and the gas condenses into its liquid form as it cools. (Pink) 5. When the cooled refrigerant Liquid goes through the Expansion Valve, the liquid evaporates back into its gaseous form in the Evaporator Coil and gets very in the evaporation process. (Blue) Then the process starts over again. And thats how geothermal heating and cooling works!

Hot Water Generator

Read more:
Geothermal Heating and Cooling Repair Information

Related Posts
November 3, 2013 at 10:00 pm by Mr HomeBuilder
Category: Heating and Cooling Repair