How To Install a Dry Wall at The Home Depot

Step 1 Measure the width of the wall and cut the sheet so it's about 14 inch shorter. Have someone help you position the sheet tight against the ceiling, and begin driving 114-inch screws in the middle of the panel at a convenient height. Step 2 Once the first screws are in place put in the rest, working your way from the center of the panel toward the outside. Drive the screws 16 inches apart into all of the studs. Step 3 A longer wall may need more than one sheet of drywall. Start by hanging a full sheet as before. Tack it in place, and then drive screws every 16 inches into the studs. Step 4

If the sheet covers a window that has yet to be installed, cover the window with a drywall panel and insert a few screws for positioning. If you have a drywall router, plunge the router into the approximate center of the window and cut sideways and vertically until you find the edges. If you don't have a router, use a handsaw.

If the window is already in place, take off the window trim and cut the window opening in the drywall sheet before you hang it. Lay out the cut by positioning the sheet along the floor and marking where it meets the bottom edge of the windows. Measure from the ceiling to the window top to lay out the top edge of the cut.

Begin the bottom row with a shorter piece so that the seam in the top row will not be directly above the seam in the bottom row. Position the piece, lift it with a panel lift, and screw it in place. When the small piece is in place, install the longer piece.

There should be a slight gap between the floor and the drywall so that the drywall won't jam against bumps in the floor. Baseboard will cover it later. If necessary, trim the sheet to leave about a 12-inch gap.

Using a spiral saw is the most effective way to cut space for outlets. Note the height of the outlet box and draw marks on the floor to show where it is. Remove the wires and screw the drywall in place, covering the box and driving just enough screws to keep the drywall in place. Find the inside edge of the box by plunging the spiral saw into the box and cutting sideways to the edges in a counterclockwise direction.

If you are using a hand saw, rub the edges of the box with lipstick and put the drywall panel in place with two screws for positioning. Remove it, and cut along the lipstick marks on the back of the panel. Reattach the panel and add drywall screws as necessary.

Continue reading here:
How To Install a Dry Wall at The Home Depot